Content in LARDIS:ONE 7

• My control center sends operation messages, but the navigation does not start - what can I do?

  LARDIS:ONE already supports all common data formats. However, if yours is not yet included, we will be happy to maintain
• How can I update the Garmin navigation device?

  Attention: With firmware versions 8.70 / 8.80 there may be problems in connection with the serial interface. These versions should
• Are there any problems with GPS reception with heated/tinted windows?

  With heated or tinted windows, there can be occasional failures with a low signal. In this case, only a GPS
• Is it possible to avoid level crossings or certain roads with the help of LARDIS:ONE 7?

  Yes, via the item "Settings - Navigation - Route Preferences - Own Avoidances" roads and areas can generally be excluded
• Is the Garmin connection cable compatible with the new 2022 hardware?

  The connection cable of the Garmin Fleet 6xx/7xx is not compatible with the new hardware 2022. With a hardware upgrade,
• My control center is not sending Tetra SDS, what other options do I have?

  Via LARDIS:ONE level converter (article: LAR-1163) it is possible to connect a POCSAG receiver with serial interface to LARDIS:ONE. To
• WLan router for telemedicine operation on LARDIS:ONE 7

  Using PTCarPhone 6, an LTE router can be easily connected to the LARDIS:ONE 7 in the vehicle. The WLan functionality
• How do I perform a factory reset on LARDIS:ONE 7 (Garmin)?

  The following steps are necessary for this:Prerequisite: Fully charge the battery. LARDIS:ONE software version min. version 2.0 If necessary, configuration exported. Execution Reset: Long press
• The map application cannot be started after a factory reset.

   ℹ️ Until version 2.2.3   To restart the map application from the LARDIS interface, long press on the "gear icon" and open
• Disabling the warning message on the LARDIS:ONE 7 (Garmin Fleet 7xx)

  As a LARDIS:ONE 7 user, you can order the article "Deactivation of the warning message in LARDIS:ONE/PILOT" from your specialist
• How do I display hydrants as POI's in my LARDIS:ONE 7?

  How can I display hydrants as POI's in my LARDIS:ONE?Using the GARMIN POI loader, you can transfer corresponding POI files

LARDIS:ONE